Custom Cycle Control Systems - Motorcycle Controls and Air Suspension

Custom Cycle Control Systems manufactures the most innovative ALL INTERNAL hand controls on the planet.These hand controls include 7 micro switches (run/off, start, L&R turn signal, horn, hi/low beam via twist grip and brake light) BOTH brake and clutch fluid reservoirs & master cylinders, grips, dual cable internal throttle assembly, throttle lock, stainless braided hoses, install kit, riser mount kit & much more. When you order a complete system it will ship fully assembled - ready to mount and install. Saves time & money. All of the switch wires, throttle cables & hoses are shipped extra long and are set up for you to cut to length. You will also get full manufacturers support! Install kit is Included and contains: • (2) add-on hydraulic fittings for the hoses • Hands Free fill funnel • throttle cables - with 4 add-on barrels (cut to length)  • 1/4x20 bleeder rod with nut & washer   • Throttle Ferrules  • Comprehensive Installation Instructions   You will need electrical connectors, banjo fittings & DOT 5 fluid. Please Specify:
9/16in clutch master cylinder for any hydraulic actuator with a 1 3/8in piston or 5/8in master cylinder for anything larger. Please contact us for advice before or when you order anything. 9/16in brake master cylinder for single disc or 5/8in brake master cylinder for dual disc. NOTE: Master cylinders have approximately 20% more travel - therefore compensate fluid displacement with travel and not diameter.  You can Use 9/16in clutch master cylinder with In-Line Slave Cylinder for Mechanical Clutch